Product Overview

The  IP65 Rated JY-7340 LED Emergency Batten shall operate in 220-240VAC with a High Efficiency Electronic Driver. The whole structure are made of vandal-resistant polycarbonate and thermoplastic enclosure.  With a durable formed gasket between the enclosure and the lens, the JY-7340 is designed specifically for hostile environments. The metal plate used to retain the reflector to dissipate heat of the LED beads, thus to lengthen the LED Driver life.

The JY-7340 is designed with 6.4V LiFePO4 Lithium battery (Cadmium free) that could work for 3 hours under the emergency mode even with high temperature, and deep discharge protection circuit.  

Key Features:

• IP65 Rated, Suitable for Wet and Damp Locations;

• 1.2m Length Batten Emergency Lighting;

• Polycarbonate lens and thermoplastic enclosure, vandal resistant;

• Microwave Motion Sensor Available with 0-10V Dimming Function;

• Cadmium Free, Built-in 6.4V Lithium Battery;

• Color Temperature 3,000K/4,000K/5,700K Options;

• Large Terminal Block for Quick and Easy Installation;

• Over and Under Charge and Discharge Protection;

• Insect-Proof Sealed LED Module;

• Ambient Operating Temperature; AC 0℃ to +40℃  and +10℃ to +40℃;

• DALI Lighting System Support;

• Expected Life of 50,000 Hours;

• Quick Wiring.

Smart Charge
Smart Charge applies in intermittent charging duty cycle designed for use with Lithium battery. Thus to provide energy efficient charging maintenance, reduce operating temperatures and optimium service life of Lithium battery.

Microwave Motion Sensor

JY-7340 support to be applied with microwave motion module built-in the lamp cap with remote setting parameters. The unit with microwave motion sensor could be installed in the site such as shop, hospital, office, corridor or warehouse with automatically turning ON/OFF the light by being triggerred with any movement.

Emergency Testing Options

Standalone

When the autotesting is not required, then the JY-7340 with standalone emergency testing mode would be more suitable which provides the same function and quality.

DALI AutoTest
When the end-user prefer to testing and mornitoring the emergency lighting system either on-site or remotely, then the JY-7340 DALI AutoTest would be the good option to monitor the whole building, especially the larger one like hospital, school and supermarket. When no need AutoTest mode and DALI network is disconnected, the unit will deafult to standalone test mode automatically.

Relevant Standards

• IEC 60598-2-22

• IEC 60598-1

• EN 55015

• EN 61000-3-2

• EN 61000-3-3

• EN 62493

• AS 2293.3

Batteries

The luminaire jy-7340 includes a rechargeable 6.4V LiFePO4 battery pack for 3 hours operation under emergency mode.

Packaging Details

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

1. All servicing should be performed by qualified service personnel.

2. Unit to be installed only as per configuration described in this instruction manual.

3. All unused wires must be capped to prevent shorting.

4. Do not let power supply cords touch hot surfaces.

5. Do not mount near gas or electric heaters.

6. Use caution when handling batteries.

7. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by unauthorized personnel.

8. Do not use accessory equipment not recommended by the manufacturer.

9. Do not use this equipment for other than intended use.